March 19, 2024, 09:49:20 am
Welcome, Guest. Please login or register
News:

Arturia Forums



Author Topic: Minibrute get stuck note when sequenced with an external source  (Read 2326 times)

shahin

  • Newbie
  • *
  • Posts: 1
  • Karma: 0
Minibrute get stuck note when sequenced with an external source
« on: February 09, 2017, 05:36:10 am »
My minibrute gets stuck notes when I try using an external sequencer, be it logic, or my korg sq-1. I had this problem with logic since the day one. I had the cycle on and after one pass, the second pass would have a note stuck. so I got a korg SQ-1 and I use CV and gate to sequence the mini. It was all good until today. same sort of problem except the note gets stuck since the first note plays. then I have to stop the sequencer and press a key on mini for the note to stop. I tried using midi out of SQ-1 but I got the same results. Anyone knows how to fix this?  :( :'(

nigel1

  • Apprentice
  • Apprentice
  • *
  • Posts: 4
  • Karma: 1
Re: Minibrute get stuck note when sequenced with an external source
« Reply #1 on: April 03, 2017, 09:07:25 pm »
shahin, from my post yesterday on the general forum for minibrute, maybe I should have posted it here


Ok, there's a message thread elsewhere on stuck note on, I was searching for it, and came across someone else, on a different thread with a similar problem.  No solution was offered on that thread, and I have no idea, yet, how to raise the issue with Bruno, the moderator. My minibrute, which I just got second hand, was working fine.Fantastic peace of kit. Then I used it to play a midi piece into reaper, via usb. It recorded the midi data ok , so I looped it and sent it back via usb to play the minibrute, which seemed to work ok, or so I thought. But then I noticed that the usual option for turning off notes in the arpeggiator did not kill the note playing. You can kill the note by rebooting, but the last note played remains playing, the moment you start playing. I noticed a few other actions could kill the sound as well, such as moving ENV speed switch from fast to slow, but it killed everything, so reboot, to the same issue. Lowering sustain to zero also killed the minibrute. I noted that in one post, there is mention of a local on/off message. The problem with trying that is that one is supposed to do this via the editor. I haven't spotted any way of doing this, and I have not noticed anyone saying the issue has been resolved. I am sure there is a solution, but I see a lot of unresolved posts, and I'm a bit apprehensive about how good tech support is. By the way, the plot was to use reaper midi tracks to sequence the minibrute, which worked, but with a cost, ha!ha!


nigel1

  • Apprentice
  • Apprentice
  • *
  • Posts: 4
  • Karma: 1
Re: Minibrute get stuck note when sequenced with an external source
« Reply #2 on: April 03, 2017, 09:35:39 pm »
Blow me down, even though I'm sure I checked it, I flicked back to posts, starting with the earliest first, and noticed  hold switch was on, at back , instead of kbd. I had been looking at the back of the keyboard from an angle, and it looked like it was on kbd. Problem solved, back to twiddling the knobs!

 

Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines