Hi, I'm new here, so apologies if this has been covered before.
I've just bought a Keylab 49 BE and it works fine with the VCollection synths running stand alone.
However, if I run the synths via Analog Lab the Keylab rotary controllers are off set as follows:
Keylab Controller 1 - mapped to Analog Lab Controller 2
KL C2 - mapped to AL C3
KL C3 - mapped to AL C4
KL C4 - mapped to AL C4 (note doubling up)
KL C5 - mapped to AL C5
I'm using the factory default mappings running on an iMac.
Any ideas please?