March 19, 2024, 05:40:03 am
Welcome, Guest. Please login or register
News:

Arturia Forums



Author Topic: LFO audible at all times on Triangle wave.  (Read 2474 times)

ricvdb

  • Apprentice
  • Apprentice
  • *
  • Posts: 13
  • Karma: -6
LFO audible at all times on Triangle wave.
« on: April 15, 2013, 05:30:33 pm »
Any idea about this?

All knobs in LFO section are zero'd in the centre (PWM/Metalizer, pitch, filter, amp).  But when the triangle wave slider is engaged, i still here the LFO affecting the signal (and can be controlled with the rate knob).  I've attached an audio clip.  Doesn't seem right.

http://www.mediafire.com/?yc2ld17cucz8iwa

ricvdb

  • Apprentice
  • Apprentice
  • *
  • Posts: 13
  • Karma: -6
Re: LFO audible at all times on Triangle wave.
« Reply #1 on: April 15, 2013, 07:18:23 pm »
note: i am adjusting the LFO rate throughout this audio clip, you hear it more noticeably when the rate is higher, a bit later in the clip

Bruno@arturia

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 501
  • Karma: 34
Re: LFO audible at all times on Triangle wave.
« Reply #2 on: May 06, 2013, 10:15:14 am »
I guess you are using a bit of metalizer in your sound.
Metalizer is a very sensitive circuit, On the pot range they are some points, especially at the beginning of the range, where metalizer sound can indeed be affected by the LFO, even if LFO amount is at center position. Being extremely sensible to power supply voltage variations, is one of the drawback of this circuit....
If you use a larger amount of metalizer, it should not be noticeable anymore.
Bruno
Arturia Hardware

 

Carbonate design by Bloc
SMF 2.0.17 | SMF © 2019, Simple Machines