Hello everyone, this is my first entry. I've had the analogue laboratory with the 61 controller for some time, but am now just getting to set it up as a master midi controller for standalone softsynths, and have run into a couple of issues. First, when I try to alter a preset on Analogue Laboratory or any other softsynths with the hardware controller, the control knobs only alter the parameter by a tiny number, yet clicking on the knob on the screen changes the parameter to the full extent. I've tried to use the manual, but so far have not been able to correct this problem. The second issue is a more important one for me since I play live and use the laptop with an Echo Indigo IOX soundcard controlling multiple softsynths. The souncard can process four stereo virtual souces as well as a stereo analogue source, all at the same time. My old controller, an Alesis QS8 works fine, but the Arturia 61 so far only controls one at a time, whichever one I launch first. To get another softsynth to sound, I have to exit the first, then launch the second- completely unworkable for playing live. I'm sure it's all in the setup, and I apologize in advance for not reading/following the manual thoroughly. Can anyone help?