Arturia Forums
V Collection - Legacy versions => Analog Lab => Analog Lab Technical Issues => Topic started by: simonc123 on December 23, 2015, 01:08:48 pm
-
Hi, I'm new here, so apologies if this has been covered before.
I've just bought a Keylab 49 BE and it works fine with the VCollection synths running stand alone.
However, if I run the synths via Analog Lab the Keylab rotary controllers are off set as follows:
Keylab Controller 1 - mapped to Analog Lab Controller 2
KL C2 - mapped to AL C3
KL C3 - mapped to AL C4
KL C4 - mapped to AL C4 (note doubling up)
KL C5 - mapped to AL C5
I'm using the factory default mappings running on an iMac.
Any ideas please?
Cheers.
-
Hi simonc123,
I'm not sure to understand your pb here.
Do you mean that knob 2 is mapped on GUI knob 3 ?
Could you try to reboot your kl while pressing oct + and - in order to reset the kl the factory settings ?
-
I re-assigned the controllers manually and that worked :)