Arturia Forums

Hardware Instruments => MiniBrute => MiniBrute Technical Questions - FAQ => Topic started by: torosufuk on October 19, 2015, 07:14:11 pm

Title: Step knob of the Arp does not work
Post by: torosufuk on October 19, 2015, 07:14:11 pm

Hi,
I am a happy Minibrute user, which is updated with the latest software, but, the step knob does not work. It always gives me the 1/4. I googled it, and could not really see a similar problem, anyone can show me a way out of it?
Thanks.

Title: Re: Step knob of the Arp does not work
Post by: NONSERIAL on February 01, 2017, 08:18:05 pm

Hey,
I experience exactly the same problem. My step-knob of the arpeggiator suddenly stopped working. Did anyone find a solution? Is this a software issue or a hardware issue?
I would really appreciate any help, because my Minibrute is pretty much useless in my current setup with the step-knob not working.
Thanks.

Title: Re: Step knob of the Arp does not work
Post by: BodoBrute on February 02, 2017, 01:51:14 pm

There is a problem with these switches (in my case it is the filter mode switch, but others have been reported). I therefore think it is rather likely that the switch itself is faulty.

Check out these two threads:
http://forum.arturia.com/index.php?topic=14177.0 (filter mode knob)
http://forum.arturia.com/index.php?topic=89846.0 (arpeggiator knob)