Arturia Forums

Hardware Instruments => MiniBrute => MiniBrute Technical Questions - FAQ => Topic started by: Conjure on April 19, 2014, 03:24:31 am

Title: MiniBrute Pitch Bend Problems
Post by: Conjure on April 19, 2014, 03:24:31 am

Hello,

I'm having issues with the pitch bend wheel on my MiniBrute. While going down, it goes to about 5-6 semitones and then just drops to 12. I know that's not normal behavior. I've heard there is a calibration tool that is given out when asked (but not available on the site)? Can someone send me this or advise on how to fix this?

Title: Re: MiniBrute Pitch Bend Problems
Post by: Conjure on April 19, 2014, 03:31:56 am

Also, when using the Metalizer, I can still fainting hear the LFO being used on it even when the PWM & Metalizer on the LFO it's set to zero. Is there a fix for this?

Title: Re: MiniBrute Pitch Bend Problems
Post by: fanu on April 19, 2014, 10:07:34 am

http://www.arturia.com/evolution/smf/index.php?topic=14302.15

Title: Re: MiniBrute Pitch Bend Problems
Post by: Conjure on April 19, 2014, 04:53:21 pm

Thanks, but that was for the MicroBrute.

I did some digging and found it here - http://www.arturia.com/evolution/smf/index.php?topic=12401.msg32686#msg32686

Works fine now.