Arturia Forums

DRUMS => Spark => Spark Technical Issues => Topic started by: storoi90 on September 18, 2012, 05:44:42 pm

Title: Draggin rendered audio into Pro Tools
Post by: storoi90 on September 18, 2012, 05:44:42 pm

Hi again,

I don´t know if this is a user-error or a Spark-error, but here´s the case.

When i render a pattern and drag it into Pro Tools, it´s just slightly of from the grid in Pro Tools. The rendered audio-clip is starting right at the grid, but just at the end it´s just a tiny-tiny fraction of from the pro tools grid.

In my session i have my tempo set at EXACTLY 95 BPM, and the Spark is also set to EXACTLY 95 BPM. I have the "Tempo" and "Host" buttons engaged also..
When i drag the clip over, it´s a small fraction off..

I tried setting the tempo to 94.9 and 95.1 in Spark, then un-clicking "Host" and "Tempo", then dragging it over.. but then it´s either a fraction over the grid or a fraction behind it.

It´s not the biggest problem in the world, but i´m just wondering if it´s something i´m doing wrong when rendering the audio in Spark?