Arturia Forums

DRUMS => Spark => Spark Users Community => Topic started by: mauronedj on July 27, 2012, 02:07:09 pm

Title: Host saved in the project
Post by: mauronedj on July 27, 2012, 02:07:09 pm

Hi to all,
As the title says, I would suggest a feature that save the Host button status in the current project and not recall the last used!

It's a handly feature for who use the midi clip from the sequencer to buil up the song in the arrangement wiew, so when the project is loaded again the spark follows the midi notes instead of the active pattern!

Mauro.

Title: Re: Host saved in the project
Post by: JDoo on July 30, 2012, 11:39:02 pm

Quick question.  What DAW are you using?  In logic, I have the Spark following the pattern that I laid into Logic.. not what is on the sequencer in Spark. 

Title: Re: Host saved in the project
Post by: Kevin on July 31, 2012, 08:56:11 am

Hi Mauro,
that is a good suggestion. TBH I don't know what is the best solution.
We had the same kind of problem with the multi out parameters.

I will discuss it with the team.

Kevin