Arturia Forums
Hardware Instruments => MicroBrute => MicroBrute Technical Questions - FAQ => Topic started by: dermich on December 18, 2013, 09:23:43 pm
-
I'm really loving my MicroBrute, but my filter doesn't seem to be calibrated exactly. When I switch to high-pass mode and turn the cutoff all the way up, I still get a bit of audio signal. It takes me to total silence when in low-pass mode with the cutoff all the way down.
Can I fix this myself?
-
Look at this thread: http://www.arturia.com/evolution/smf/index.php?topic=14538.0 -> Side 2
I got my second Microbrute today. Will went to store again tomorrow. Early bird catches the worm, early adopter catches bugs. >:(
-
Look at this thread: http://www.arturia.com/evolution/smf/index.php?topic=14538.0 -> Side 2
I got my second Microbrute today. Will went to store again tomorrow. Early bird catches the worm, early adopter catches bugs. >:(
I don't think this answer is related.
By design the HP filter does not completely close, only the LP does. So you can't calibrate it.
-
Is it possible that this depends on calibrating the modwheel? Since I've done that I was not able to trigger Microbrute to play forever. Before calibrating it was easy. I will test it a little bit. Hm.
-
Since I've done that I was not able to trigger Microbrute to play forever.
For the sequencer it's an option is Microbrute Connection: "hold"
for Gate hold you can check this:
http://www.arturia.com/evolution/smf/index.php?topic=14378
-
I think, you get me wrong. I will try to make a video of it. If I do Highpass, Cutoff 50%, Resonance Max and then playing with amount and rate of lfo it sometimes hangs up and plays forever without sequenzer. Since I've calibrated the Modwheel I was not able to trigger this. I will try to kick it when I'm at home.
-
Thank you Bruno - that is exactly the answer I needed. This is definitely my favorite synth I've bought in ages.