Arturia Forums
DRUMS => Spark => Spark Users Community => Topic started by: fella on February 04, 2013, 04:18:52 am
-
Hello, can someone please tell me if you can run through the presets with using just the controller? Also, Is there a way to assign the filter or any other effect besides the roller, to a single channel/pad? I don't want the effect going over the whole song. Any help on this would be great!! thanks
-
hold down the big knob with the A on it in the top right hand corner ... it will change modes and allow you to start flipping through projects instead of each instrument
don't know about the roller honestly, i think that is stuck as it is. you could set one of the three knobs (above the pad) to the filter value, by holding "select" and then scrolling the knob you want to change until you get the parameter you want on it
-
Thanks, but that just changes the kit or the instrument it doesn't change the preset, I know that that you can change the kit or change the instrument by holding down the Knob with the big A on it switching between the two.
I just want to run through the presets with the controller.. i guess theres no way to do that with the controller (silly)
and just so i have this correct, I cannot have the Fx pad assigned to just one sound,ie the the filter section or the slicer, I have to have it going over the whole project?
I guess only the roller works on individual sounds..
-
what do you mean the presets? you mean the "projects?"
there's a way to change the jog mode from "kit" to "project"
i forget how though because i did it almost immediately after getting the spark and never looked back
"and just so i have this correct, I cannot have the Fx pad assigned to just one sound,ie the the filter section or the slicer, I have to have it going over the whole project?"
no, that's exactly what the roller is intended to do...you just keep pressing roller until it says what you want to change (filter, aux send, etc) and it will only effect the selected instrument...otherwise no. but not sure if you are aware the the roller can control the filter and such
have you read through the manual?
-
Sorry I mean projects. I just read the 1.5 new features and saw about the rollers functions and thats exactly what i was looking for. I also came across switching projects with the jog wheel.. first you have to set it up in the prefs to be able to do that .
Thanks for your help and time!!
-
awesome, glad you got it!
enjoy! :)
-
ya, I wish it worked a bit different tho, to do with the fx roller section anyway. i wish it wouldn't do cut off and res together or send to both aux at the same time . Plus, i still cant figure out how to enter latch mode using the controller .. i know you right click on the software to enter latch mode and the roller button will blink stating that ur in latch mode, but i cant figure it on the hardware.
Do you know how to enter latch mode from the controller?
thanks
-
yeah but i think it's a good compromise
think of the fx pad as an x/y grid...so try to find where your bd doesnt sound different for at all when your finger is on it (for cutoff / res) then only move in straight lines from there. annoying but doable
hardware, to enter latch mode, you hold "select" then hit the button you want to go into latch (filter, slicer, or roller)
-
Thanks so much man, really appreciate all the help!
-
sure, np!
;D