Arturia Forums
Hardware Instruments => MiniBrute => MiniBrute Technical Questions - FAQ => Topic started by: jooechip on December 01, 2012, 05:40:57 am
-
Hi Bruno,
Would you be able to allow a slower lfo rate when the lfo clock toggle is set to 'Arpeg'?
I'd like much slower rates that allow slow evolving synced filter sweeps (e.g. 2 or 4 bars length). Maybe the LFO speed could also be set to change in relation to the arpeg step rate (currently it doesn't change)?
Thanks,
Joe
-
Hi,
When the Lfo is clock synced to the arpeggiator, when you dial FLO Rate knob, that will set LFO rate to 4, 2, 1, 1/2 or 1/4 of the Arp Tempo.
Either you haven't noticed that already, either I didn't understood your request.
I didn't added more subdivisions, because it would have made it to difficult to find (very narrow) when dialing the Rate knob.
-
When the Lfo is clock synced to the arpeggiator, when you dial FLO Rate knob, that will set LFO rate to 4, 2, 1, 1/2 or 1/4 of the Arp Tempo.
Either you haven't noticed that already, either I didn't understood your request.
Thanks for the reply,
I did notice the LFO is stepped at 5 points. However, the lowest speed setting is still too fast in my opinion. It certainly doesn't sound like it's 1/4 of the tempo.
Joe
-
please take into consideration the fact that the saw rate is twice the other waveform rate, so for the saw it's 8, 4, 2, 1, 1/2